Support
NexDock 360 – Battery Replacement

STEP 1
-
Remove the 10 screws securing the lower case to the upper case.
NOTE: Throughout this repair, keep track of each screw and make sure it goes back exactly where it came from to avoid damaging your device.

STEP 2
-
Remove 2 hidden screws located underneath the rubber grips at the back (closer to the hinge)
NOTE: You don’t need to completely remove the rubber feet for removal of the hidden screws (see the image)

STEP 3
-
Remove the back panel by pulling up gently from the side edge.
NOTE: Pay attention to the power button (shown by arrow) while removing the case. Otherwise, you could damage the button.

STEP 4
-
Remove the black tapes on the PCBA

STEP 5
-
Locate the cable attaching the battery to the motherboard and gently unplug it.
NOTE: Carefully disconnect the cable parallel to the board, not at an angle. Otherwise, you could damage the port.

STEP 6
-
Remove the 5 screws securing the battery to the lower case.