Support
NexDock Touch – Display Replacement
STEP 1
-
Remove the eleven screws securing the lower case to the upper case.
NOTE: Throughout this repair, keep track of each screw and make sure it goes back exactly where it came from to avoid damaging your device.
STEP 2
-
Remove 2 hidden screws located underneath the rubber grips at the back (closer to the hinge)
STEP 3
-
Remove the back panel by pulling up gently from the front edge.
STEP 4
-
Remove the 2 black tapes on the PCBA
STEP 5
-
Locate the cable attaching the battery to the motherboard and gently unplug it.
NOTE: Carefully disconnect the cable parallel to the board, not at an angle. Otherwise, you could damage the port.
STEP 6
-
Unlock the latch of the the ribbon display cable, by sliding the hooks forward.
-
Once latch are unlocked, pull the ribbon cable out to detach them from the motherboard.
STEP 7
-
Open the display 90 degrees and place the device at the edge of the table as shown.
-
Remove the six screws securing the lower case to the display.
-
Remove the display gently from the lower case